I posted on this revolver once before, but since I had a chance to shoot one of these the other day, and I think it's a fine piece, decided to show it again.
It's about identical in outside dimensions to a K-frame S&W revolver, with the frame, barrel and cylinder being forged of titanium. The barrel and each chamber has a stainless steel liner(to take the pressure and hold rifling), and the lockwork is steel. The combination gives a revolver holding five rounds of .45acp that weighs the grand total of about 1.5 pounds. The steel versions have a vented barrel, and I believe some of the titanium models in other cartridges are vented also.
Since it fires a rimless cartridge it uses a steel moon clip to hold five rounds. Five instead of six means the cylinder can be that much smaller in diameter, which means a smaller frame, so smaller AND lighter for easy carry. These clips are not as heavy and stiff as those used in some other revolvers, so for fast reloads I'd think something like a speedloader carrier to set them into.
The grip is a ribbed, soft rubber that both fits to your hand very well and does a good job of soaking up recoil, the latter being a Good Thing in a pistol this light. Sights are fixed.
The action on those I've fired have all been very smooth with a light, clean single-action pull. Double was a bit heavy; I'd imagine it would lighten up much like a S&W revolver, though you'd have to make damn sure you didn't scratch the titanium surfaces inside.
I'm told they don't make this model any longer, which is a pity. It's light, well made, of a size that will fit a lot of hands, in a serious cartridge, and quite accurate. For something to carry on hikes, or as a concealed-carry piece it would work nicely.
No comments:
Post a Comment